Switching Line Access Code Detection On/Off - Auerswald COMpact 3000 analog Operating Manual

Settings
Analogue Connection

Switching Line Access Code Detection On/Off

Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
4. Select or clear the Transmit line access code automatically check box under Line
connection.
Enables line access code transmission.
Disables line access code transmission. (No other action is required.)
5. In the Transmit line access code automatically entry field under Line connection,
enter the required digit or digit sequence. The following entries are possible:
Up to 16 digits
Digits and the characters * and #
Further steps:
– Save your settings before you leave the page.
Switching Line Access Code Detection On/Off
If line access code detection is enabled, a dialling pause of 3 seconds is automatically inserted
after the digit/digit sequence entered is dialled.
This is necessary if the central office requires a pause after the line access code entered has
been dialled.
Switching this on/off can be done as follows:
380
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020