Configuring The Exchange Line Access Number - Auerswald COMpact 3000 analog Operating Manual

Settings
Exchange Line Access

Configuring the Exchange Line Access Number

Further steps:
– Save your settings before you leave the page.
Configuring the Exchange Line Access Number
The exchange line access number is required to request an external line (exception: direct
exchange access).
Note: An available external line is indicated by the external dial tone after the
exchange line access number has been dialled. The external telephone
number can then be dialled.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External telephone numbers > Location.
2. In the entry field Exchange line access number, change the exchange line access
number. The following entries are possible:
1 digit in the range of
Note:
The factory settings for the exchange line access number on the PBX is "0".
Changing the exchange line access number is only meaningful if another
exchange line access number is normally used (e.g., in England).
Note that changing the exchange line access number restricts the telephone
number plan.
The exchange line access number 8 is restricted. It is required for internal
PBX use.
Further steps:
500
)
0 to 7 and
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
9