Dialling A Telephone Number On Direct Exchange Line Access - Auerswald COMpact 3000 analog Operating Manual

Telephoning
Outgoing Calls

Dialling a Telephone Number on Direct Exchange Line Access

External telephone number
dial the exchange line access number before dialling the telephone number.)
** and short code number
omit the **.)
Once you have finished dialling the telephone number, the subscriber will be called.
The telephone number display suppression has been enabled for this call.
Note:
You can also use this function on analogue telephones, where it can be
performed via the T-Net function key/menu (optional, see manual for the
telephone).
On some ISDN telephones and on the COMfortel 1100/1500/1600/2500/
2500 AB/VoIP 2500 AB/2600 system telephones, this function can also be
called via an existing function key or via the menu (optional, see manual for
the telephone).
Dialling a Telephone Number on Direct Exchange Line Access
Requirements:
– The subscriber has a direct exchange line access (as delivered ex-factory).
In order to dial an external telephone number on a direct exchange line access point, pick up
the receiver and enter the external telephone number without the exchange line access
number.
In order to make other types of calls (e. g. internal or short-code), proceed as described in the
following.
1. Pick up the receiver.
2. Dial **.
3. Enter an internal telephone number.
Once you have finished dialling the telephone number, the subscriber will be called.
106
(If you do not use a direct exchange line access,
(If you do not use a direct exchange line access,
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020