Switching Loop Current Detection For Line Connection On/Off - Auerswald COMpact 3000 analog Operating Manual

• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
4. Select or clear the Detect line access code and wait check box under Line
connection.
Enables the detection of the line access code entered.
Disables the detection of the line access code entered. (No other action is
required.)
5. In the Detect line access code and wait entry field under Line connection, enter
the required digit or digit sequence for which a dialling pause should be inserted after
it is dialled. The following entries are possible:
Up to 16 digits
Digits
Further steps:
– Save your settings before you leave the page.

Switching Loop Current Detection for Line Connection On/Off

If loop current detection for the line connection is enabled, the PBX checks whether loop
current is present on the line to be connected.
Note:
If loop current is detected, the line is then used.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
Switching Loop Current Detection for Line Connection On/Off
Settings
Analogue Connection
381