Auerswald COMpact 3000 analog Operating Manual page 61

– Under unfavorable conditions, for example, near a strong transmitter or an electrical power
line: screened cable
– For telephones or combination fax/answering machines: a TAE wall socket with F coding (a
single socket labeled with an F)
– For fax machines, modems, and call answering machines: a TAE wall socket with an
additional socket with N coding
Note: Outside of Germany, use RJ-45 sockets or the analogue wall sockets
normally used in the country in question.
1. Lay the line.
Note: Prevent interferences. Avoid laying long lengths of parallel lines,
especially next to mains. Twist the pairs.
2. Attach the wires to the two terminal clamps at the internal a/b port.
3. Connect the wall sockets to the terminal clamps at the internal a/b port.
The figure in the following shows the position of the terminal clamps under the cover
panel, as well as the connection set up to a TAE wall socket with F coding.
Further steps:
– Connect the end devices to the wall sockets.
Note: For TAE wall sockets, insert the connectors for the telephones or
combination fax/answering machines into the socket labeled with F and insert
the connectors of the remaining devices into the socket labeled with N.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Installation and Commissioning
Installing Cables and Wall Sockets at the Internal a/b Port
Analogue End Devices
61