Connecting The Cable And The Wall Sockets To The Internal U P0 Port - Auerswald COMpact 3000 analog Operating Manual

Installation and Commissioning
ISDN End Devices
Connecting the Cable and the Wall Sockets to the Internal U
Connecting the Cable and the Wall Sockets to the Internal U
Warning: Power surges, which can occur during electrical storms, can
cause life-threatening electric shocks or damage/destroy the PBX.
• Lay all the cables inside the building.
Requirements:
– Cover panel is removed
– Internal U port (only provided at the optionally available COMpact ISDN module)
P0
– Terminators enabled at the internal U
– Installation cable (z. B. J-Y(St)Y 2x2x0,6)
– Under unfavorable conditions, for example, near a strong transmitter or an electrical power
line: screened cable
– ISDN wall sockets (e. g. IAE or UAE8)
Caution: Terminals integrated in the wall sockets are destroyed and can
damage the device.
• In comparison with the S
• Remove terminals which have already been integrated in the wall
– Compliance with the maximum distance/line length between the devices, depending on the
cable used (with a pair diameter of 0.6 mm: unscreened max. 1000 m, screened max.
600 m)
– U /S adapter
P0 0
Note:
For connecting one single COMfortel 1100/1200/1400/1500/1600/2500/2500
AB/2600 system telephone, a U
You do not need an ISDN wall socket if you use a U
S adapter can be mounted on the wall or it can be connected to the PBX via
0
the two screw terminals on the back.
1. Lay the line.
68
port
P0
with terminals. These are already integrated in the end devices
(COMfortel 1100/1200/1400/1500/1600/2500/2500 AB/2600 or U
adapter).
sockets for the usage at the U
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Port
P0
port, do not equip a line end at the U
0
port.
P0
/S adapter is not necessary.
P0 0
P0
Port
P0
P0
P0
/S adapter. The U /
0 P0
port
/S
0