Configuring The Clip Sub-Version - Auerswald COMpact 3000 analog Operating Manual

4. In the Type of CLIP information list field under CLIP, select one of the following
options:
no: The network provider sends no CLIP information.
FSK: The network provider sends the CLIP information via frequency shift
keying.
DTMF and DTMF (MaxComm): The network provider sends the CLIP infor-
mation via dual tone multi frequency.
Further steps:
– Save your settings before you leave the page.

Configuring the CLIP Sub-version

The CLIP sub-version indicates when the analogue network provider sends the CLIP infor-
mation.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– CLIP service attribute enabled with the network provider (telephone number display)
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
4. In the CLIP sub-version list field under CLIP, select when the CLIP information will
be sent by the network provider.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
Settings
Analogue Connection
Configuring the CLIP Sub-version
393