Operating Instructions For The Configuration Manager - Auerswald COMpact 3000 analog Operating Manual

Open the configuration manager as an administrator
Requirements:
– A PC meeting the minimum requirements (see chapter Important Information > Minimum
Requirements PC)
– An existing Ethernet connection between the PC and the PBX or both the PC and the PBX
on the same network
– Knowledge of the IP address on the PBX
– Knowledge of the admin password
Note: If the UPnP service is installed and enabled on the PC being used, the
PBX is identified and selected as the "Auerswald PBX" device in the network
environment. The configuration manager is then opened in the browser.
Steps 1 and 2 are omitted. Proceed with Step 3.
1. Start a browser (for example, Mozilla Firefox or Google Chrome).
2. Enter the IP address of the PBX in the address field of the browser (for example,
http://192.168.178.4).
3. Enter the admin user name and the associated admin password.
4. Click Log-in.
The configuration manager opens.
Further steps:
– Configure the desired settings in sequence (page for page).

Operating Instructions for the Configuration Manager

The operating instructions for the configuration manager contain the following topics:
• Navigation
• Logging Out
• Entry and Selection Fields
• Creating and Deleting Table Entries
• Symbols and Highlightings
• Display/Legibility
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Basic Knowledge Configuration Manager
Operating Instructions for the Configuration Manager
Configuration Manager
83