– The user password is configured for the internal telephone number.
Note: The prerequisite for the execution described here is that the telephone
be operated as a DHCP client in the network. If this is not the case, refer to
the Commissioning Instructions for the telephone.
1. Connect end devices with a separate power supply to the 230 V mains.
2. Select the language.
3. Enter the internal telephone number as an MSN for the end device.
4. Enter the user password for the end device.
The end device searches for the PBX.
5. Confirm the displayed IP address for the PBX.
The end device logs on to the PBX.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Installation and Commissioning
Putting VoIP System Telephones into Operation
Commissioning
79