Switching The Use Of Any Available Call Channels On/Off; Configuring The Delay Time For Call Forwarding For External Numbers On No Reply - Auerswald COMpact 3000 analog Operating Manual

Switching the Use of Any Available Call Channels On/Off

For call forwarding your own external telephone number via the PBX (setting Feature via PBX
(2nd call channel)), the B-channel belonging to the port is used by default in addition to the B-
channel assigned by the outgoing call. Since the probability of call forwarding not being carried
out due to a busy B-channel is then higher, any B-channel can be enabled.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External S port (only COMpact 3000 ISDN or COMpact ISDN module available as an
0
option), external VoIP channel and created VoIP account
– Configuration manager, opened with sufficient authorisation
– Expert view (click
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the ISDN connection in question.
A page opens for configuring the ISDN connection.
3. Open the page ISDN connection > Name and functions.
4. Select or clear the Use any available call channel check box.
Enables the use of any available call channels.
Disables the use of any available call channels.
Further steps:
– Save your settings before you leave the page.
Configuring the Delay Time for Call Forwarding for External Numbers on No
Reply
The delay time for call forwarding on no reply for external numbers indicates after how many
seconds a call is forwarded if the subscriber called does not respond.
The delay time applies only to call forwarding that has been configured via the PBX. For a
configured call forwarding configured at the network provider, the delay time depends on the
network provider and cannot be set via the PBX.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
Switching the Use of Any Available Call Channels On/Off
Functions
Call Forwarding
213