Entering The Name For The Isdn Connection - Auerswald COMpact 3000 analog Operating Manual

Settings
ISDN Connection

Entering the Name for the ISDN Connection

Enables S
Disables S
Further steps:
– Save your settings before you leave the page.
Entering the Name for the ISDN Connection
The name of the connection is used for identification purposes. For example, it is shown on the
display of the internal subscriber for incoming external calls (alpha-numeric CLIP-capable or
ISDN subscribers).
The entry can be made as follows:
• Via the configuration manager
Requirements:
– External S port (only COMpact 3000 ISDN or COMpact ISDN module available as an option)
0
– Configuration manager, opened with sufficient authorisation
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the ISDN connection in question.
A page opens for configuring the ISDN connection.
3. Open the page ISDN connection > Name and functions.
4. In the Name of the connection entry field, enter the desired name. The following
entries are possible:
Up to 16 digits
Digits and characters
Further steps:
– Save your settings before you leave the page.
400
bus monitoring.
0
bus monitoring.
0
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020