Switching Intercom Permission On/Off - Auerswald COMpact 3000 analog Operating Manual

Functions
InterCom Announcement/Handsfree

Switching InterCom Permission On/Off

1. Pick up the receiver.
2. Dial one of the following character strings:
##011: Initiates an InterCom announcement.
##012: Initiates InterCom handsfree.
3. Enter the internal phone number of the system telephone. The following entries are
possible:
** and internal telephone number of the individual system telephone
you do not use a direct exchange line access, omit the **.)
The system telephone automatically takes the call after a single ring.
Switching InterCom Permission On/Off
If InterCom permission is enabled, InterCom announcement or InterCom handsfree is enabled
on the InterCom destination in question.
Switching this on/off can be done as follows:
• Separately for subscribers
• Via the configuration manager
• Using the menu/function key on a system telephone (optional, see the telephone manual)
Requirements:
– Configuration manager, opened with sufficient authorisation
– System telephone that supports InterCom (optional, see telephone manual)
– Internal S port (only provided on the COMpact S
0
available as an option) or internal VoIP channels (COMpact 3000 VoIP or acquired in the
Upgrade Center and released VoIP channels)
– Expert view (click
1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >
Authorizations.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the InterCom (announcement/handsfree speaking) check box.
Enables InterCom permission.
Disables InterCom permission.
238
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
module or COMpact ISDN module
0
(If