Calling A Third Subscriber And Transferring To An Active Communication Partner - Auerswald COMpact 3000 analog Operating Manual

Telephoning
Transfer

Calling a Third Subscriber and Transferring to an Active Communication Partner

Note: On many ISDN phones, the termination of a query call on busy is not
performed automatically, but via a function key or via the menu (optional, see
manual for the telephone).
2. Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone).
3. Dial ##07.
You will hear the confirmation tone.
4. Hang up the receiver.
The external communication partner continues to listen to hold music.
As soon as the internal subscriber hangs up the receiver, this external communication
partner is called. Once he accepts the call, he is connected with the subscriber in the
waiting loop.
Note: If the internal subscriber does not answer the call within 60 seconds or
the line remains busy during the three-minute waiting time, the call will be
transferred back to you. If you pick up the receiver, you will be reconnected
with the external communication partner. You can then place him in the
waiting loop again. If you do not pick up the call within 60 seconds, the
exchange line connection is disconnected completely (for example, if your
line was busy even for a short time).
Calling a Third Subscriber and Transferring to an Active Communication Partner
Requirements:
– Initiated query call
During a query call, proceed as described in the following.
1. Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone).
2. Dial 5.
3. Enter a telephone number. The following entries are possible:
122
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020