Creating A Voip Provider - Auerswald COMpact 3000 analog Operating Manual

Hide thumbs Also See for COMpact 3000 analog:

Table of Contents

– If necessary, change the standard settings according to the data provided by your VoIP

Creating a VoIP provider

Six VoIP providers are already pre-configured in the factory settings. A total of up to ten VoIP

providers can be created.

Creation can be carried out as follows:

• Via the configuration manager

Requirements:

– External VoIP channel (COMpact 3000 VoIP or VoIP channels purchased and activated in

the Upgrade Center)

– Configuration manager, opened with sufficient authorisation

1. Open the page CONFIGURATION > Voice over IP (VoIP) > VoIP provider.

2. Enter the name of the VoIP provider in the first available Name entry field. The

following entries are possible:

Up to 16 digits

Digits and characters

in the line of the corresponding VoIP provider.

The page Provider configuration > Provider opens, and under Provider name, the

assigned name is displayed.

Further steps:

– Configure addition settings on the Provider configuration page.

Note: The data required for the settings on the Provider configuration page

are provided directly by the VoIP-provider or can be found in corresponding

lists in the Internet.

– Save your settings before you leave the page.

COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020

Creating a VoIP provider

Compact 3000 isdn Compact 3000 voip