Configuring Local And Remote Ip Addresses - Auerswald COMpact 3000 analog Operating Manual

Service and Maintenance
Remote Configuration and Alternative Connection Options

Configuring Local and Remote IP Addresses

The PIN entry dialogue opens.
19. Enter the associated PIN in the PIN entry field and click OK.
The configuration is saved on the telephone. This may take a while.
Configuring Local and Remote IP Addresses
The local IP address indicates which IP address is the one assigned to the PBX after a dial-up
connection has been established (e.g., for the remote configuration) and is therefore the one
to enter in the address field in the browser.
The remote IP address indicates which IP address is assigned to the PC after login for the
duration of the session. This means that the computer and the PBX are on the same network
and can communicate.
Important: If the factory-set remote IP address is already being used on the
computer network, thereby causing IP addresses to overlap, complications
will occur. To avoid this, you must change the remote IP address and
therefore the local IP address at the same time. This should result in both IP
addresses being again located on the same network.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Expert view (click
1. Open the page CONFIGURATION > Server configuration > Network.
2. Enter the IP address in the Local IP address entry field under PPP configuration.
The following entries are possible:
IP address with a range of 0 to 255 (example: 103.103.103.103)
3. Enter the IP address in the Remote IP address entry field under PPP configuration.
The following entries are possible:
IP address with a range of 0 to 255 (example: 103.103.103.103)
Further steps:
544
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020