Configuring The Waiting Time For The Line Connection; Switching Line Access Code Transmission On/Off - Auerswald COMpact 3000 analog Operating Manual

Configuring the Waiting Time for the Line Connection

The waiting time for the line connection indicates how many seconds the PBX should wait
before dialling a telephone number.
This is necessary if the external dial tone generated by the central office is not transmitted until
after a long waiting period which results in the PBX initiating a dialling sequence that is too early
and causes incorrect dialling.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
4. In the Waiting time entry field under Line connection, enter a value. The following
entries are possible:
3 to 30: After 3 to 30 seconds, the PBX dials a telephone number or as soon as
the central office transmits the dial tone (if waiting for dial tone is enabled).
Further steps:
– Save your settings before you leave the page.

Switching Line Access Code Transmission On/Off

If line access code transmission is enabled, the digit/digit sequence entered is automatically
inserted before the telephone number dialled.
This is necessary if the central office always requires a specific leading digit/digit sequence that
is not a part of the actual telephone number.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
Configuring the Waiting Time for the Line Connection
Settings
Analogue Connection
379