Auerswald COMpact 3000 analog Operating Manual page 359

The basic assembly has four analogue ports. It is possible to add two ports is using a
COMpact 2a/b module.
The creation can be carried out as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
1. Open the page CONFIGURATION > Internal numbers > Analogue subscribers.
The pre-configured analogue subscribers are displayed.
Note: The creation is also provided during the quick configuration using the
configuration wizard.
2. If necessary, change one of the internal telephone numbers displayed or enter a new
internal number in the From entry field under Telephone numbers. The following
entries are possible:
2 to 4 digits in the range of
Note:
Double allocation of a number is not possible.
The telephone numbers 70, 80, 87, 701-706, 801-806, 875-879 and 8750-
8799 cannot be freely allocated. They are required for internal PBX use.
Using telephone numbers with few digits (two or three-digit numbers) inevi-
tably restricts the possible supply of telephone numbers with more digits. For
example, if the telephone number 12 is assigned, the telephone numbers
120-129 and 1200-1299 are no longer available.
The default exchange line access number on the PBX is "0" in the factory
settings; however, this can be changed. Note that changing the exchange line
access number restricts the telephone number plan.
3. Enter a name for identification purposes in the Name entry field. The following entries
are possible:
Up to 16 digits
Digits and characters
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
10 to 9999
Settings
Internal Telephone Numbers
Creating Analogue Subscribers
359