Service Data; Switching Output Of The D-Channel Protocol Over Ip On/Off - Auerswald COMpact 3000 analog Operating Manual

Service and Maintenance

Service Data

Switching Output of the D-Channel Protocol over IP On/Off

Service Data
If the PBX ever displays a malfunction, various reports can be recorded. These reports can then
be forwarded to technical departments (Service, Development) to help find the cause of the
malfunction.
Switching Output of the D-Channel Protocol over IP On/Off
If the D-channel output via IP option is selected, anyone within the network can record a D-
channel protocol over IP.
Important:
Observe the following legal notes before permitting D-channel output via IP.
After permission, every computer within the LAN network can record a D-
channel protocol of the PBX without any further password protection.
It might be that the recorded protocol includes the following components:
- Connection data sets with destination, source, and time information of a
telecommunication connection
- Configuration data of the PBX and connected telephones, as well as the
corresponding PINs and passwords
- Telephone book of the PBX
Before any recording, all participants in the telecommunication connection
must be informed that these contents will be recorded and must also be
informed who will use the recorded data.
If you want to make the recorded data available to your specialised dealer or
to the manufacturer for error analysis, you must make sure that the legal
requirements are fulfilled.
You can switch the D-channel protocol on or off as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with a sufficient authorisation level
1. Open the CONFIGURATION > Server configuration > Network page.
562
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020