Voip End Devices; Connecting Voip End Devices To The Ethernet Port - Auerswald COMpact 3000 analog Operating Manual

VoIP End Devices

This section describes how to connect different VoIP end devices to the Ethernet port.
Important: Improper use may, for example, cause functional restrictions or
interference, the destruction of the device or, in a worst case scenario,
personal injury.
• Only connect equipment that is compatible with the proper use of the

Connecting VoIP End Devices to the Ethernet Port

Requirements:
– Internal VoIP channel (COMpact 3000 VoIP or VoIP channels obtained at the Upgrade Center
and enabled by it)
– Line lengths between the ethernet devices shorter than 100 m
– Patch cable
– Single switch or individual network (LAN) with a recommended transmission rate of 100 Mbps
Note: For VoIP data communication in combination with the transmission of
limited amounts of data, a data transmission rate in the LAN of 10 Mbps is
sufficient under certain circumstances. For VoIP data communication in
combination with the transmission of large amounts of data (e. g.
downloads), we recommend upgrading to a data transmission rate of
100 Mbps. For this purpose, replace not only all of the active network compo-
nents (e. g. switch and router), but also all of the passive network compo-
nents (e. g. cables and wall sockets). For a reliable support of 100 Mbps, you
need cables and wall sockets of at least Category 5 (CAT5).
– To use DiffServ to prioritize speech packets: DiffServ support on all active network compo-
nents available and enabled
Note: When using a switch with PoE function, a separate power supply (e. g.
via a power supply unit) is not normally required for connected VoIP
telephones.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
PBX.
Installation and Commissioning
Connecting VoIP End Devices to the Ethernet Port
VoIP End Devices
71