Reading The Lcr Configuration From The Pbx - Auerswald COMpact 3000 analog Operating Manual

Functions
LCR

Reading the LCR Configuration from the PBX

Note: This meter pulse is fully billed by the provider even if the call is ended
before this time has elapsed.
14. In the second Meter pulse interval (1st pulse / second pulse) entry field, enter
which charge pulse time unit is used to bill a call after the first meter pulse. The
following entries are possible:
1 to 6000
Note:
For second pulses of differing lengths, enter the most unfavorable meter
pulse.
The provider bills each started meter pulse in full.
15. Repeat steps 4 to 14 to create additional entries.
Further steps:
– Save your settings before you leave the page.
Reading the LCR Configuration from the PBX
A completely created LCR configuration can be read out of the PBX and saved on the PC.
Data can be read out as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
1. Open the page FUNCTIONS > Least Cost Routing > LCR data.
2. Click Read from PBX under Export LCR data.
A dialogue for downloading the configuration file "softlcr.txt.gz" opens.
3. Save the configuration file on a data storage medium (PC).
266
sec.: Specifies the second pulse from 1 to 6000 seconds.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020