Switching Continuous Tone Detection At End Of Call On/Off - Auerswald COMpact 3000 analog Operating Manual

Enables busy tone detection.
Disables busy tone detection. (No other action is required.)
5. In the Minimum length of busy signal entry field, enter a value. The following entries
are possible:
3 to 20: The PBX must detect a busy signal sequence for 3 to 20 seconds to
end the call. The purpose of this is to prevent, for example, speech from being
interpreted as a busy signal.
Further steps:
– Save your settings before you leave the page.

Switching Continuous Tone Detection at End of Call On/Off

If continuous tone detection is enabled, the network provider sends a continuous tone via the
PBX; this signal is interpreted as the end of the call connection.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Network provider support for the continuous tone at the end of a call
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
4. Select or clear the Continuous tone check box under End of the call.
Enables continuous tone detection.
Disables continuous tone detection.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
Switching Continuous Tone Detection at End of Call On/Off
Settings
Analogue Connection
389