Saving Configuration Data On The Pc - Auerswald COMpact 3000 analog Operating Manual

Requirements:
– PBX set to factory settings
– The configuration file (auconfig.cfg) saved on a USB memory stick or SD card saved
Note: The configuration file must be named "auconfig.cfg".
1. Turn the PBX off.
2. Insert the USB memory stick into the USB port (USB host) or the SD card into the SD
card slot on the PBX.
3. Turn the PBX on.
The configuration data saved on the USB memory stick or on the SD card saved is
automatically saved in the PBX. Finally, restart the PBX.
If the "Power" LED lights up in green again, the restart is complete and the PBX is
ready for operation.
Note: If the "Power" LED remains continuously lit in red, an error has
occurred. Please contact your dealer or the manufacturer directly.

Saving Configuration Data on the PC

Important:
Observe the following legal notes before saving the data backup.
The data backup includes, amongst others, the following legally especially
protected components:
- Configuration of the PBX
- Names of internal subscribers
- Passwords of PBX, subscribers, VoIP accounts and VoIP subscribers
- The Telephone book of the PBX
Before the data backup is being saved, all subscribers to the PBX must be
informed that these contents will be forwarded. They must also be informed
about who will use the data received.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Service and Maintenance
Backing Up and Recovering Configuration Data
Saving Configuration Data on the PC
527