Configuring The Time Lapse For Forced Logout - Auerswald COMpact 3000 analog Operating Manual
Hide thumbs
Also See for COMpact 3000 analog:
- Installation, operation and configuration instructions (608 pages) ,
- Quick start instructions (2 pages)
Table of Contents
Advertisement
Basic Knowledge Configuration Manager
Configuration Manager
Configuring the Time Lapse for Forced Logout
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
1. Open the page CONFIGURATION > Server configuration > Access and PBX data.
2. Enter a value in the Max. number of logged-in users at the same time entry field
under Log-in. The following entries are possible:
0
to 10: A range of 0 to 10 users can log in simultaneously in the configuration
manager.
Further steps:
– Save your settings before you leave the page.
Configuring the Time Lapse for Forced Logout
The time lapse for a forced logout defines after how many minutes a user is automatically
logged out of the configuration manager if no action has been taken in the configuration
manager within a configured time period.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
1. Open the page CONFIGURATION > Server configuration > Access and PBX data.
2. Enter a value in the Forced logout if no action happens after entry field under Log-
in. The following entries are possible:
5
to 60: After 5 to 60 minutes, you are automatically logged out if no action has
been taken on the configuration manager during this period of time.
Further steps:
– Save your settings before you leave the page.
92
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Advertisement
Table of Contents
