Switching Automatic Configuration Switchover On/Off - Auerswald COMpact 3000 analog Operating Manual

2. Click the tab of the configuration of which the settings are to be copied.
3. For the parts exchange line authorisation, do-not-disturb, baby call, call deblocker,
call restrictor:
a) Open the page PROPERTIES > Internal subscribers > Subscriber properties
(configuration-dependent).
b) Only select the check boxes of the functions which are to be activated depending
on the configuration.
c) Configure the required settings for the activated functions.
d) Click
4. In the Apply settings in configuration list field, select the configuration to which the
settings are to be copied.
5. Click Copy.

Switching Automatic Configuration Switchover On/Off

If automatic configuration switchover is enabled, time-controlled configurations are toggled
according to the PBX internal clock.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Minimum of two configured configurations and configured switching times
– current PBX time
1. Open the page FUNCTIONS > Configurations > Settings.
2. Select or clear the Automatic configuration switching check box.
Enables automatic configuration switchover.
Disables automatic configuration switchover.
Further steps:
– Save your settings before you leave the page.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
.
Configuration Switchover
Switching Automatic Configuration Switchover On/Off
Functions
245