Pickup; Executing Pickup - Auerswald COMpact 3000 analog Operating Manual

Functions

Pickup

Executing Pickup

Pickup
Using Pickup, you can take a call on your own phone that was originally sent to another internal
telephone.
If the call has already been taken, the call can be taken using same procedure if the call take-
over has been allowed by the subscriber being called. This function is useful, for example, in
the case of answering machines.
Executing Pickup
Performing this procedure can be carried out as follows:
• Using a character string on the internal telephone
• Using the menu/function key on a system telephone (optional, see the telephone manual)
Requirements:
– Authorization Pickup assigned to the subscriber
– To pick up an external call: Exchange line authorisation assigned to the subscriber for
incoming calls (International, National, City or only incoming, with emergency call)
If an internal telephone rings in your proximity, proceed as described in the following.
1. Pick up the receiver of your telephone.
2. Dial ##06.
3. Enter the internal telephone number of the telephone that is ringing. The following
entries are possible:
** and internal telephone number of the individual telephone
use a direct exchange line access, omit the **.)
** and internal telephone number of the line group
direct exchange line access, omit the **.)
You are connected with the caller.
280
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
(If you do not
(If you do not use a