Configuring The Network Port On The Tapi Server - Auerswald COMpact 3000 analog Operating Manual

– Configuration manager, opened with sufficient authorisation
– Expert view (click
1. Open the page FUNCTIONS > LAN TAPI > LAN TAPI subscribers.
2. Select or clear the check box next to the corresponding subscriber.
Selects the subscriber for LAN-TAPI.
Clears the subscriber for LAN-TAPI.
Further steps:
– Save your settings before you leave the page.

Configuring the Network Port on the TAPI Server

According to the factory settings, the network port on the TAPI server is pre-defined at 7001 by
default.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Expert view (click
1. Open the page FUNCTIONS > LAN TAPI > LAN TAPI configuration.
2. In the Network port (1024-65535) under TAPI server entry field, enter the port
number on the TAPI server. The following entries are possible:
1024 to
Further steps:
– Save your settings before you leave the page.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
)
65535
Configuring the Network Port on the TAPI Server
Functions
LAN-TAPI
251