Analogue Connection; Entering The Name For The Analogue Connection - Auerswald COMpact 3000 analog Operating Manual

Analogue Connection

The COMpact 3000 analogue provides an external analogue port on both the German and
international PBX models.
On the German PBX models, this analogue port has already been configured with the default
settings that are required for analogue ports in Germany. When a country is selected, the inter-
national models are automatically configured with the default settings required for analogue
ports in the country selected.
In addition, it is possible to change the country-specific settings via the configuration manager.

Entering the Name for the Analogue Connection

The name of the analogue connection is used for identification purposes. For example, it is
shown for incoming external calls on the display of the internal subscriber (alpha-numeric CLIP-
capable or ISDN subscribers).
The entry can be made as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Configuration manager, opened with sufficient authorisation
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Name and functions.
4. In the Name of the connection entry field, enter the desired name. The following
entries are possible:
Up to 16 digits
Digits and characters
Further steps:
– Save your settings before you leave the page.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Analogue Connection
Entering the Name for the Analogue Connection
Settings
371