Interrupt Control Modes And Interrupt Operation; Interrupt Control Mode 0; Table 5.3 Interrupt Control Modes - Renesas H8SX/1520 Series Hardware Manual

Section 5 Interrupt Controller
5.6

Interrupt Control Modes and Interrupt Operation

The interrupt controller has two interrupt control modes: interrupt control mode 0 and interrupt
control mode 2. Interrupt operations differ depending on the interrupt control mode. The interrupt
control mode is selected by INTCR. Table 5.3 shows the differences between interrupt control
mode 0 and interrupt control mode 2.
Table 5.3 Interrupt Control Modes
Interrupt
Control Mode
0
2
5.6.1

Interrupt Control Mode 0

In interrupt control mode 0, interrupt requests except for NMI are masked by the I bit in CCR of
the CPU. Figure 5.3 shows a flowchart of the interrupt acceptance operation in this case.
1. If an interrupt request occurs when the corresponding interrupt enable bit is set to 1, the
interrupt request is sent to the interrupt controller.
2. If the I bit in CCR is set to 1, only an NMI interrupt is accepted, and other interrupt requests
are held pending. If the I bit is cleared to 0, an interrupt request is accepted.
3. For multiple interrupt requests, the interrupt controller selects the interrupt request with the
highest priority, sends the request to the CPU, and holds other interrupt requests pending.
4. When the CPU accepts the interrupt request, it starts interrupt exception handling after
execution of the current instruction has been completed.
5. The PC and CCR contents are saved to the stack area during the interrupt exception handling.
The PC contents saved on the stack is the address of the first instruction to be executed after
returning from the interrupt handling routine.
6. Next, the I bit in CCR is set to 1. This masks all interrupts except NMI.
Rev. 3.00 Mar. 14, 2006 Page 112 of 804
REJ09B0104-0300
Downloaded from Elcodis.com electronic components distributor
Priority Setting Interrupt
Register Mask Bit
Default I
IPR I2 to I0
Description
The priority levels of the interrupt sources are
fixed default settings.
The interrupts except for NMI is masked by the
I bit.
Eight priority levels can be set for interrupt
sources except for NMI with IPR.
8-level interrupt mask control is performed by
bits I2 to I0.