Renesas H8SX/1520 Series Hardware Manual page 684

Section 17 Flash Memory (0.18-(m F-ZTAT Version)
(7)
Command Order
The order for commands in the inquiry selection state is shown below.
1. A supported device inquiry (H'20) should be made to inquire about the supported devices.
2. The device should be selected from among those described by the returned information and set
with a device-selection (H'10) command.
3. A clock-mode inquiry (H'21) should be made to inquire about the supported clock modes.
4. The clock mode should be selected from among those described by the returned information
and set.
5. After selection of the device and clock mode, inquiries for other required information should
be made, such as the multiplication-ratio inquiry (H'22) or operating frequency inquiry (H'23),
which are needed for a new bit-rate selection.
6. A new bit rate should be selected with the new bit-rate selection (H'3F) command, according
to the returned information on multiplication ratios and operating frequencies.
7. After selection of the device and clock mode, the information of the user boot MAT and user
MAT should be made to inquire about the user boot MATs information inquiry (H'24), user
MATs information inquiry (H'25), erased block information inquiry (H'26), and programming
unit inquiry (H'27).
8. After making inquiries and selecting a new bit rate, issue the transition to
programming/erasing state command (H'40). The boot program will then enter the
programming/erasing state.
Rev. 3.00 Mar. 14, 2006 Page 646 of 804
REJ09B0104-0300
Downloaded from Elcodis.com electronic components distributor