Figure 17.26 Erasure Sequence - Renesas H8SX/1520 Series Hardware Manual

• Erasure
Erasure is executed by the erasure selection and block erasure commands.
Firstly, erasure is selected by the erasure selection command and the boot program then erases
the specified block. The command should be repeatedly executed if two or more blocks are to
be erased. Sending a block erasure command from the host with the block number H'FF will
stop the erasure operating. On completion of erasing, the boot program will wait for selection
of programming or erasing.
The sequence for the erasure selection and block erasure commands is shown in figure 17.26.
Repeat
Downloaded from Elcodis.com electronic components distributor
Host
Preparation for erasure (H'48)
Erasure (Erasure block number)

Figure 17.26 Erasure Sequence

Section 17 Flash Memory (0.18-(m F-ZTAT Version)
ACK
ACK
Erasure (H'FF)
ACK
Rev. 3.00 Mar. 14, 2006 Page 649 of 804
Boot program
Transfer of erasure
program
Erasure
REJ09B0104-0300