Interrupt Sources; Table 9.39 Tpu Interrupts - Renesas H8SX/1520 Series Hardware Manual

Section 9 16-Bit Timer Pulse Unit (TPU)
9.5

Interrupt Sources

There are three kinds of TPU interrupt sources: TGR input capture/compare match, TCNT
overflow, and TCNT underflow. Each interrupt source has its own status flag and enable/disable
bit, allowing generation of interrupt request signals to be enabled or disabled individually.
When an interrupt request is generated, the corresponding status flag in TSR is set to 1. If the
corresponding enable/disable bit in TIER is set to 1 at this time, an interrupt is requested. The
interrupt request is cleared by clearing the status flag to 0.
Relative channel priority levels can be changed by the interrupt controller, but the priority within a
channel is fixed. For details, see section 5, Interrupt Controller.
Table 9.39 lists the TPU interrupt sources.

Table 9.39 TPU Interrupts

Channel Name
0 TGI0A
TGI0B
TGI0C
TGI0D
TCI0V
1 TGI1A
TGI1B
TCI1V
TCI1U
2 TGI2A
TGI2B
TCI2V
TCI2U
Rev. 3.00 Mar. 14, 2006 Page 326 of 804
REJ09B0104-0300
Downloaded from Elcodis.com electronic components distributor
Interrupt Source
TGRA_0 input capture/compare match
TGRB_0 input capture/compare match
TGRC_0 input capture/compare match
TGRD_0 input capture/compare match
TCNT_0 overflow
TGRA_1 input capture/compare match
TGRB_1 input capture/compare match
TCNT_1 overflow
TCNT_1 underflow
TGRA_2 input capture/compare match
TGRB_2 input capture/compare match
TCNT_2 overflow
TCNT_2 underflow
DMAC
Interrupt Flag Activation
TGFA_0 Possible
TGFB_0 Not possible
TGFC_0 Not possible
TGFD_0 Not possible
TCFV_0 Not possible
TGFA_1 Possible
TGFB_1 Not possible
TCFV_1 Not possible
TCFU_1 Not possible
TGFA_2 Possible
TGFB_2 Not possible
TCFV_2 Not possible
TCFU_2 Not possible