Engine Coolant Temperature Sensor - SSANGYONG Rexton Y200 Manual

1F2-90 M161 ENGINE CONTROLS
Notice: Before removal, the fuel rail assembly may
be cleaned with a spray-type cleaner, following
package instructions. Do not immerse the fuel rails
in liquid cleaning solvent. Use care in removing
the fuel rail assembly to prevent damage to the
electrical connectors and injector spray tips.
Prevent dirt and other contaminants from entering
open lines and passages. Fittings should be
capped and holes plugged during service.
Important: If an injector becomes separated from
the rail and remains in the cylinder head, replace
the injector O-ring seals and the retaining clip.
YAA1F770
12. Remove the injectors and the fuel rail carefully.
13. Remove the fuel injector retainer clips.
14. Remove the fuel injectors by pulling them down
and out.
15. Discard the fuel injector O-rings.
16. Lubricate the new fuel injector O-rings with engine
oil. Install the new O-rings on the fuel injectors.
17. Perform a leak check of the fuel rail and fuel
injectors.
18. Installation should follow the removal procedure
in the reverse order.
ENGINE COOLANT TEMPERATURE
SENSOR
Removal and Installation Procedure
1. Relieve the coolant system pressure.
2. Disconnect the negative battery cable.
3. Disconnect the engine coolant temperature sensor
connector.
Notice: Take care when handling the engine
coolant temperature sensor. Damage to the sensor
will affect the proper operation of the fuel injection
system.
YAA1F780
4. Remove the engine coolant temperature sensor
from the pump hosing.
Installation Notice
Tightening Torque
5. Installation should follow the removal procedure
in the reverse order.
30 N•m (22 lb-ft)
SSANGYONG Y200