SSANGYONG Rexton Y200 Manual page 242

SSANGYONG Y200
M161 ENGINE MECHANICAL 1B2-81
1. Check the piston ring gap and apply the engine
oil to the piston pin and the connecting rod
bushing.
2. Connect the piston and the connecting rod by
pressing in the piston pin (6) and install the snap
ring to the groove.
3. Clean the cylinder bore, connecting rod bearing
journal, connecting rod bearing shell and the
piston and coat them with engine oil.
4. Install the piston ring.
5. Install the piston so that the arrow on the piston
head faces to the forward of the vehicle.
YAD1B2S0
6. After aligning the connecting rod and the bearing
cap mark (// or a number), tighten the bolts.
Installation Notice
Tightening Torque
Apply the engine oil to the bearing cap upper and
lower bearing shells.
7. Check if the crankshaft rotates without any trouble
by rotating it.
1st step : 40 N•m (30 lb-ft)
2nd step : 90 °