SSANGYONG Rexton Y200 Manual page 1042

5A-174 AUTOMATIC TRANSMISSION
4. Install the rear servo lever and pivot pin.
Notice: The lever must pivot freely on its pin.
KAA5A890
5. Assemble the park rod lever, complete with the
return spring and pivot pin, applying a small
amount of sealant to the outer end of the pivot
pin.
Notice: Care must be taken when applying sealant
to ensure that it is not applied between the pin and
the lever.
6. Secure the pivot pin with the circlip.
Notice: The lever must pivot freely on its pin and
the spring must return the park rod lever to its correct
location.
KAA5A640
7. Install the parking pawl pivot pin and spring.
Notice: The pawl must pivot freely on its pin.
KAA5A900
8. Connect the park rod to the manual valve detent
lever. Ensure the spring and cam collar is firmly
installed on the rod.
9. Check that the cam collar slides freely on the rod.
10. Insert the cross shaft into the case, from the side
opposite to the inhibitor switch, then install the
antirattle spring on the shaft.
KAA5A910
SSANGYONG Y200