SSANGYONG Rexton Y200 Manual page 121

1B1-80 M162 ENGINE MECHANICAL
Removal Procedure
1. Position the No.1 cylinder to TDC (OT).
Notice: Remove the oil filler cap at adjustment
position, and check whether the intake camshaft
cam's lobe (arrow) stays in the upper side.
2. Cover the generator with a clean cloth.
3. Release the tension by unscrewing the screw plug
once.
Notice: In case that the tension is reduced by
unscrewing the screw plug, reinstall after
completely removing the chain tensioner. If the
YAD1B1P0
chain tensioner is tightened again without
completely reducing its tension, then the detent
spring doesn't return to the original position and
the tension gets exceeded.
4. Carefully unscrew the screw plug (1), and remove
the seal (2).
Notice:
•
For the removal of screw plug, be careful that it
can be jumped out due to the force of
compression spring.
•
Remove the screw plug only when the seal and
compression spring are damaged.
YAD1B1Q0
5. Carefully remove the filler pin (3), compression
spring (4), snap ring (5), and the thrust pin (6).
6. Remove the chain tensioner housing (7) and the
seal (8).
YAD1B1R0
SSANGYONG Y200