Table of Contents
Advertisement
Step
1. Use a scan tool to clear all DTCs.
1
2. Road test the vehicle.
Does DTC 110 set again?
1. Check all system wiring harness connectors and
terminals, especially the electronic brake control
module (EBCM), for any problem that could cause
2
an intermittent condition.
2 Repair any intermittent problem found.
Is the repair complete?
Check fuse SB2.
3
Is fuse SB2 blown?
1. Check for a short circuit and repair it, if necessary.
4
2. Replace fuse SB2.
Is the repair complete?
1. Disconnect the motor relay.
2. Check the resistance between the motor relay
5
connector terminal 17 and terminal 18 of EBCM.
Is the resistance equal to the specified value?
Repair the open circuit between the motor relay
connector terminal 17 and fuse SB2 of EBCM.
6
Is the repair complete?
1. Turn the ignition to ON.
2. Check the voltage between the motor relay
7
connector terminal 15 and ground of EBCM.
Is the voltage equal to the specified value?
1. Repair the open circuit between the motor relay
connector terminal 87 and terminal 14 of hydraulic
modulator.
8
2. Road test the vehicle
Does DTC 110 clear?
1. Replace the hydraulic modulator/EBCM.
9
2. Road test the vehicle
Does DTC 110 clear?
SSANGYONG Y200
DTC 110 - Pump Motor or Pump Motor Relay Fault
Action
ABS AND TCS 4E-77
Value
Yes
-
Go to Step 3
-
System OK
-
Go to Step 4
-
System OK
11 - 14 V
Go to Step 7
-
System OK
11 - 14 V
Go to Step 9
-
System OK
-
System OK
No
Go to Step 2
-
Go to Step 5
-
Go to Step 6
-
Go to Step 8
Go to Step 9
-
Advertisement
Chapters
Table of Contents
