Chain Tensioner - SSANGYONG Rexton Y200 Manual

1B2-64 M161 ENGINE MECHANICAL
1 Screw Plug ............................... 40 N•m (30 lb-ft)
2 Seal
3 Filler Pin
4 Compression Spring
5 Snap Ring

CHAIN TENSIONER

6 Thrust Pin
7 Chain Tensioner Housing
.................................. 72 - 88 N•m (53 - 65 lb-ft)
8 Seal
Removal Procedure
1. Position the number 1 cylinder to ATDC 20 ° .
Notice: Remove the oil filler cap at adjustment
position, and check whether the intake camshaft
cam's lobe (arrow) stays in the upper side.
2. Cover the generator with a clean cloth.
3. Release the tension by unscrewing the screw plug
once.
Notice: In case that the tension is reduced by
unscrewing the screw plug, reinstall after
completely removing the chain tensioner. If the
YAD1B1P0
chain tensioner is tightened again without
completely reducing its tension, then the snap ring
doesn't return to the original position and the
tension gets exceeded.
YAD1B1N0
SSANGYONG Y200