SSANGYONG Rexton Y200 Manual page 813

3D-22 REAR AXLE
Assembly
1. Clean all parts and check the followings.
•
Check the ring gear, drive pinion for wear and
damage. If damaged, replace it as a set.
•
Check the bearing for sticks, wear, noise and
turning resistance.
•
Check the side gear, pinion, pinion shaft and
thrust washer for wear and damage.
•
Check the differential carrier for crack and wear
(bearing contact surface). Check the gear case
for crack.
YAD3D590
2. Assemble the drive pinion assembly to the axle
housing and then tighten the pinion lock nut.
Installation Notice
Tightening torque
YAD3D600
3. Assemble the differential carrier assembly. Align
the ring gear to the mark of differential carrier,
tighten the fixing bolts.
Installation Notice
Tightening Torque
YAD3D610
4. Measure the backlash of side gear and pinion gear.
Specified value
YAD3D620
240 - 310 N•m
75 - 90 N•m
(55 - 66 lb-ft)
0 - 0.5 mm
SSANGYONG Y200