1F1-12 M162 ENGINE CONTROLS
1 Crankshaft Position Sensor
2 Bolt
This Electronic Ignition (EI) system uses inductive or pick up type magnetic Crankshaft Position (CKP) sensor.
The CKP sensor is located in the opposite side of the crankshaft pulley and triggers the pick-up wheel teeth
which is equipped 60 - 2 teeth with a gap of 2 teeth at 360 degree spacing. This sensor protrudes throughits
mount to within 1.1 ± 0.14 mm.
The output of the sensor is a sinusoidal signal. Each tooth of the pick-up 60 - 2 wheel generates a positive half
wave.
The Engine Control Module (ECM) uses this sensor signal to generate timed ignition and injection pulses that it
sends to the ignition coils and to the fuel injectors.
CRANKSHAFT POSITION (CKP) SENSOR
3 Segment
4 Flywheel
YAD1F110
SSANGYONG Y200