Throttle Body (Integrated With The Actuator) - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200
M162 ENGINE CONTROLS 1F1-89
THROTTLE BODY (INTEGRATED
WITH THE ACTUATOR)
Removal and Installation Procedure
1. Disconnect the negative battery cable.
2. Disconnect the mass air flow sensor connector.
3. Disconnect the mass air flow sensor from the air
filter housing.
4. Remove the intake air duct mounting bolts.
Installation Notice
Tightening Torque
KAA1F010
5. Remove the air inlet housing clamps.
6. Remove the inlet air housing.
7. Disconnect the throttle body electrical connector.
8. Remove the throttle body bolts.
Installation Notice
Tightening Torque
9. Remove the vacuum hose.
KAA1F230
10. Remove the throttle body and discard the gasket.
Important: Use care in cleaning old gasket
material. Sharp tools may damage sealing
surfaces.
11. Installation should follow the removal procedure
in the reverse order.
KAA1F240
9 N•m (80 lb-ft)
12 N•m (106 lb-ft)