Upper/Lower Arm Assembly - SSANGYONG Rexton Y200 Manual

2C-14 FRONT SUSPENSION
3. Fix the shock absorber yoke at the lower arm bolt
hole and insert to tighten the yoke mounting pin
to the hole.
Installation Notice
Tightening Torque
YAD2C210

UPPER/LOWER ARM ASSEMBLY

Removal Procedure
Notice: Perform the pre-work before the removal
procedure.
•
Remove the shock absorber.
•
Remove the steering knuckle by referring the
steering section.
1. Remove the mounting nut (slotted nut) and the
split pin (cotter pin) from the upper/lower arm ball
joint.
YAD2C220
Notice: Separate the ball joint from the steering knuckle
using the special tool as shown.
YAD2C230
2. Remove mounting bolts and nuts of the upper arm/
frame bracket (both front and rear) and separate
the upper arm.
YAD2C240
150 - 180 N•m
SSANGYONG Y200