SSANGYONG Rexton Y200 Manual page 583

1F2-60 M161 ENGINE CONTROLS
Acceleration Pedal Position Sensor 1 Inspection
1. Turn the ignition switch to "ON" position.
2. Measure the signal voltage between the ECM pin No. 47 and No. 31 while operating the accelerator pedal as
following conditions.
•
Not depress the pedal (closed throttle position)
•
Fully depress the pedal (full throttle with kick down)
Condition of Throttle
Valve
Closed Throttle Valve
Fully Depressed Throttle
Valve
Notice: If measured value is not within the specified value, check the pedal valve sensor and the supply
voltage to APP 1 sensor.
Acceleration Pedal Position Sensor 2 Inspection
1. Turn the ignition switch to "ON" position.
2. Measure the signal voltage between the ECM pin No. 48 and No. 50 while operating the accelerator pedal as
following conditions.
•
Not depress the pedal (closed throttle position)
•
Fully depress the pedal (full throttle with kick down)
Condition of Throttle
Valve
Closed Throttle Valve
Fully Depressed Throttle
Valve
Notice: If measured value is not within the specified value, check the pedal valve sensor and the supply
voltage to APP sensor 2.
Specified Value (V)
0.3 ~ 0.7
4.3 ~ 4.8
Specified Value (V)
0.1 ~ 0.4
2.1 ~ 2.5
SSANGYONG Y200