Maintenance And Repair; Bleeding The Brakes - SSANGYONG Rexton Y200 Manual

Hide thumbs Also See for Rexton Y200:

Table of Contents

4A-6 BRAKE SYSTEM

MAINTENANCE AND REPAIR

For Master Cylinder and Wheel Cylinder

Notice: The bleeding sequence is as follows; right rear,

left rear, right front and left front.

Check the fluid level and add fluid during the bleeding

1. Raise the vehicle with the assistance worker riding

up to replenish the oil in the brake oil reservoir

2. Remove the bleeder screw and cap.

3. Attach a transparent tube over the valve. Allow

the tube to hang submerged in brake fluid in a

transparent container.

4. Slowly push the brake pedal several times and

hold the brake pedal.

5. Tighten the bleeder screw after loosening the

bleeder screw and draining the fluid.

Notice: Hold the brake pedal until tightening the

bleeder screw.

6. Repeat the step 5, 6 until all the air is removed.

7. Check the leaks for the bleeder screw.

8. Bleed air in the system at four wheels in order as

shown in the figure if pressure building is not

enough by depressing the pedal after above air

Always bleed the air after replacing brake fluid

or master cylinder, caliper, brake hose and pipe.

Do not reuse the bled brake fluid.

Rapid pumping of the brake pedal pushes the

master cylinder secondary piston down the bore

in a manner that makes it difficult to bleed the

Care must be taken to prevent the brake fluid

contacting any painted surface to prevent

damage to the paint finish.

Check any leak for the applicable portion after

SSANGYONG Y200

Table of Contents