SSANGYONG Rexton Y200 Manual page 905

Step
Install the scan tool and check for any DTCs.
1
Is any DTC set?
1. Turn the ignition to LOCK.
2. Disconnect the scan tool.
3. Turn the ignition to ON.
2
4. Observe the ABS indicator lamp.
Does the lamp illuminate for about 2 seconds, then
turn off?
With the ignition still ON, observe the oil pressure
lamp.
3
Is the oil pressure lamp illuminated?
1. Turn the ignition to LOCK.
2. Disconnect the connector from the electronic brake
4 control module (EBCM).
3. Turn the ignition switch to ON.
Does the ABS indicator illuminate?
1. Turn the ignition to LOCK.
2. Examine terminals 16 and 20 at the EBCM connector
5
on both the ABS wiring harness and on the EBCM.
Is there a poor connection at any of these terminals?
Repair the faulty terminals or replace the ABS unit, as
required.
6
Is the repair complete?
Replace the ABS unit.
7
Is the repair complete?
1. Turn the ignition to LOCK.
2. Disconnect the wire from the negative battery
terminal.
3. Measure the resistance between the negative
8
battery wire, which is attached to ground, and the
shorting bar in the EBCM connector.
Is the resistance equal to the specified valve?
Repair the open or high resistance in the circuit from
EBCM connector, terminal 16 to ground G106.
9
Is the repair complete?
1. Remove the I/P cluster.
10 2. Remove and check the ABS indicator bulb.
Is the bulb burned out?
1. Replace the ABS indicator bulb.
11
2. Install the I/P cluster.
Is the repair complete?
Check the continuity at the I/P cluster connector
terminal B7.
12
Is the continuity equal to the specified value?
Repair the contact at the I/P cluster connector terminal
B7.
13
Is the repair complete?
SSANGYONG Y200
ABS Indicator Lamp Inoperative
Action
ABS AND TCS 4E-21
Value Yes
Go to the
- DTC table
Go to
"Intermittent
and Poor
- Connections"
- Go to Step 4
- Go to Step 5
- Go to Step 6
- System OK
- System OK
≈ 0 Ω
Go to Step 10
- System OK
- Go to Step 11
- System OK
≈ 0 Ω
Go to Step 14
- System OK
No
Go to Step 2
Go to Step 3
Go to Step 19
Go to Step 8
Go to Step 7
-
-
Go to Step 9
-
Go to Step 12
-
Go to Step 13
-