Maintenance And Repair; On-Vehicle Service; Discharging The Pressure In Fuel System; Fuel Pump - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200

MAINTENANCE AND REPAIR

KAA1F430
KAA1F440
YAA1F170
M162 ENGINE CONTROLS 1F1-83

ON-VEHICLE SERVICE

DISCHARGING THE PRESSURE IN
FUEL SYSTEM
Removal and Installation Procedure
1. Remove the fuel pressure test connector.
Installation Notice
Tightening Torque
2. Remove the fuel pressure in fuel system by
pressing the service valve with a clean, pointy
tool.
Notice: Place a cloth so that the fuel doesn't stain
around.
3. Installation should follow the removal procedure
in the reverse order.

FUEL PUMP

Tools Required
661 589 00 46 00 Fuel Tank Cap Wrench
Removal and Installation Procedure
Caution: The fuel system is under pressure. To avoid
fuel spillage and the risk of personal injury or fire,
it is necessary to relieve the fuel system pressure
before disconnecting the fuel lines.
1. Relieve the fuel system pressure. Refer to
"Discharging the Pressure in Fuel System" in this
section.
2. Disconnect the negative battery cable.
3. Put aside the floor carpet to remove the fuel pump
access cover.
4. Remove the fuel pump access cover.
5. Remove the fuel pump wiring connectors.
6. Disconnect the fuel supply and return pipes.
7. Remove the fuel pump locking cap band.
25 N•m (18 lb-ft)