SSANGYONG Rexton Y200 Manual page 676

1F3-52 DIESEL ENGINE CONTROLS
Tools Required
116 589 02 34 00 Threaded Bolt
116 589 20 33 00 Sliding Hammer
601 589 00 08 00 Flange
601 589 05 21 00 Locking Screw
667 589 04 63 00 Retaining Plate
Removal & Installation Procedure
1. Remove the bolts (2) and then remove the cylinder
head cover (1) and gasket (3).
Installation Notice
YAD1BCV0
Tightening Torque
Replace the gasket.
Rotate the engine 1 revolution by hand and check
TDC marking of the crankshaft and camshaft.
2. Loosen the camshaft sprocket bolt (14).
Installation Notice
Tightening Torque
Do not remove the bolt.
If max. length of bolt exceeds 53.6 mm, replace
it.
YAD1FCG0
3. Loosen the bolt (11) (left-hand thread).
Installation Notice
Tightening Torque
Do not remove the bolt.
YAD1FCH0
10 N•m (89 lb-in)
25 N•m (18 lb-ft)+ 90°
46 N•m (34 lb-ft)
SSANGYONG Y200