SSANGYONG Rexton Y200 Manual page 1050

5A-182 AUTOMATIC TRANSMISSION
15. Position the cylinder with the C1 cavity upwards.
Install the piston into the cylinder until the outer
diameter of the piston enters the inner diameter
of the cylinder.
16. Install the spring and spring retainer onto the
piston.
17. Using 0555-336259 clutch spring compressor,
compress the spring sufficiently to enable the
installation of the retaining circlip ensuring that
the circlip is firmly seated in its groove, then
remove the tool.
Notice: The wire diameter of this spring is 5.26 mm.
KAA5A0H0
18. Install the C2 wave washer into the cylinder with
the crest of one wave covering one of the bleed
orifices inthe C2 piston.
19. Measure and record the thickness of the flange of
the C2 sleeve.
20. Install the C4 clutch plates and wave washer into
the C2 actuating sleeve, with the rounded edge of
the steel plates down, in the following sequence:
•
Steel plate (selective)
•
Friction disc
•
Steel plate
•
Friction disc
•
Steel plate
•
Friction disc
•
Steel plate
KAA5A0I0
•
Wave washer
SSANGYONG Y200