Wheel Joint Assembly - SSANGYONG Rexton Y200 Manual

3A-28 FRONT AXLE

WHEEL JOINT ASSEMBLY

Disassembly
1. Remove the drive axle.
2. Detach the joint boot clamp.
1 Detach the boot clamp (large)
2 Detach the boot clamp (Small)
•
After unfolding the clamp holding part by using
the driver/hammer, detach the clamp.
YAD3A710
3. Get rid of the grease in the joint assembly.
4. Remove the joint assembly.
1 Spread out the circlip.
2 Pull out the joint assembly to the wheel side
with the circlip spread out.
YAD3A720
5. Remove the drive axle shaft.
YAD3A730
Assembly
1. Assembly should follow the disassembly
procedure in the reverse order.
2. Install the joint assembly.
•
Put the joint assembly in drive axle shaft to
spread out the circlip opening slightly.
1 Inser t (-) driver into the circlip opening to spread
out the circlip.
2 Put the joint assembly in circlip home with the
circlip spread out.
YAD3A740
SSANGYONG Y200