Accelerator Pedal Module - SSANGYONG Rexton Y200 Manual

1F1-58 M162 ENGINE CONTROLS
1 Accelerator Pedal
2 Accelerator Pedal Sensor
3 Bolts
The Acceleration Pedal Position (APP) sensor is mounted on the accelerator pedal assembly. The sensor is
actually two individual APP sensors and one housing. This sensor works with the Throttle Position (TP) sensor to
provide input to the Engine Control Module (ECM) regarding driver requested accelerator pedal and throttle angle
at the throttle body.
When the APP sensor is defected:
When the APP1 or APP 2 sensor is defected condition, the engine is still running at idle condition but, the
accelerator pedal reaction is not response correctly and also, the engine rpm will be reacted to 4,000 rpm slowly.
If the APP 1 sensor is out of order, the APP 2 sensor will be conducted with signal as a default signal but, the
throttle valve opening is limited 60% and delayed opening speed.
When the TP sensor or servo motor is defected:
When the TP 1, 2 sensor or servo motor is defected condition, the throttle valve will be closed to the spring
capsule by spring force, at this condition, the throttle valve will open 10° ~ 20° and engine rpm will be controlled
by ECM with opening (On/Off) time of injector. The engine rpm will be maintaining 900 rpm (at idle) to 1,800
according to the engine load.

ACCELERATOR PEDAL MODULE

4 6-Pin Connector
5 Kick-down Switch
6 Nut
YAD1F480
SSANGYONG Y200