SSANGYONG Rexton Y200 Manual page 1033

SSANGYONG Y200
AUTOMATIC TRANSMISSION 5A-165
15. Remove the two centre support retaining bolts
using a T50 Torx bit.
16. Remove the centre support retaining circlip.
Notice: Do not hammer the output shaft to remove
the centre support as this will cause permanent
damage to the thrust bearing surfaces.
17. Remove the centre support, 1-2 one way clutch,
and planetary gear set as an assembly.
18. Remove the parking rod cam plate using a T40
Torx bit.
KAA5A560
19. Remove the rear band struts and remove the band.
Notice: Vise the both end of rear band using the
plier and lean forward about 15 degrees
20. Remove the output shaft assembly.
KAA5A570
Transmission Case
Tools Required
0555-336258
0555-336261
0555-336265
1. Remove the pin from the side of cross shaft
inhibitor switch using cross shaft pin remover/
installer (inhibitor switch) 0555-336265.
2. Remove the inhibitor switch bolts and inhibitor
switch from the case.
KAA5A580
3. Remove the cross shaft seals with cross shaft seal
remover 0555-336261.
4. Remove the circlip from the cross shaft. Pull the
shaft to release the drive pin from the selector
quadrant.
KAA5A590
Cross Shaft Pin Remover/Installer
(Detent Lever)
Cross Shaft Seal Remover
Cross Shaft Pin Remover/Installer
(Inhibitor Switch)